Table 3.11-1 — Host Router To DRM Mapping Table
Host DynaStar Router 00 (host_a) DRM1 – DRM5
Host DynaStar Router 01 (host_b) DRM6 – DRM10
Host DynaStar Router 02 (host_c) DRM11 – DRM 15
• After software is downloaded to the remote DynaStar router, a reset is performed
to restart the router to run the new software. During the reset, communication is
lost between the ASM and the single DRM accessed by the remote router for
approximately 5 minutes.
Once communication is lost between the ASM and DRM(s), ASM services will begin to
fail resulting in multiple error messages on the ROP. The ASM GUI and DRM 124
display page will also show the status for the ASM services as degraded. It may take
up to 30 minutes for the ASM to restore the services after the network connection has
been restored.
Executing this procedure to download software and re-initialize a Cajun switch will
take approximately 10 minutes.
Executing this procedure to download software and re-initialize a DynaStar router will
take approximately 10 minutes, not including ASM or DRM backups.
Required Tools
Access to the ASM with root permission is required.
Required Conditions
Log onto the ASM with root permission. If an HA-ASM configuration is being used,
perform this procedure from the “lead” ASM. For more information, see Section
“Accessing the ASM,” in 235-200-145, OneLink Manager Administrative Services
Module User’s Guide.
Required Information
Before beginning this procedure, obtain the passwords and the IP addresses for the
ASM and Cajun switch or DynaStar routers that will be downloaded with new
software. This information should be stored in the office records. The following table
provides the Lucent defined default IP addresses, a column to record the customer
defined IP addresses if used, and a column to record the network element software
version number.
NETWORK PROCEDURES
Procedure 3.11
235-200-150
August 2004
Page 3.11-2 Issue 3.00K
To Next Page
Loading...
Need help?
General