20. Before installing the new secondary disk, enter luxadm insert_device.Ifthe
following response is received continue with step 21. If this response is not
received, seek technical assistance.
Response:
Please hit 〈RETURN〉 when you have finished adding Fibre Channel
Enclosure(s)/Device(s):
21. Install HDD1 (right disk)
a. Holding the drive handle, push the drive into the drive bay until it makes
contact with the Fibre Channel backplane connector.
b. Lock the drive in the bay by pressing on the drive handle until the drive
latch closes.
22. Refit the front fascia on the workstation.
23. Enter return at the console prompt. If the following response is not received, seek
technical assistance.
Response:
Waiting for Loop Initialization to complete...
New Logical Nodes under /dev/dsk and /dev/rdsk :
c1t1d0s0
c1t1d0s1
c1t1d0s2
c1t1d0s3
c1t1d0s4
c1t1d0s5
c1t1d0s6
c1t1d0s7
No new enclosure(s) were added!!
24. Log off (exit).
25. To partition and propagate the system to the non-active disk, follow steps in
procedure “Partition and Propagate the System to the Non-Active Disk”4.5.6.
26. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
ADMINISTRATIVE WORKSTATION MAINTENANCE
Procedure 4.5.2
235-200-150
October 2005
Page 4.5.2-4 Issue 3.00B
To Next Page
Loading...