6.2 Perform Office Terminal Software Initialization
OVERVIEW
Initialize office terminal software at a DRM site.
Warning: Performing the following procedure will disable the terminal
equipment until initialization is completed.
PROCEDURE
1. At Master Control Center (MCC) video terminal, is the EMERGENCY ACTION
INTERFACE (EAI) PAGE displayed?
If YES, proceed to Step 3
If NO, continue with next step.
2. At MCC video terminal, depress EA DISP key to display EMERGENCY ACTION
PAGE
Response: EMERGENCY ACTION PAGE is displayed.
3. On the EAI PAGE, type and enter: 42; n; 15;
Where: n = The level of craft initialization 1, 2, or 3 (start with level 1 and
escalate to level 3).
1 Craft initialization level 1 terminates and restarts all craft processes
and also restarts MTTY controllers.
2 Craft initialization level 2 terminates and restarts all killable
nonessential user and supervisor processes and also restarts all
MTTY and TTY controllers.
3 Craft initialization level 3 terminates and restarts all killable
essential and non-essential user and supervisor processes.
Response: craft initialize? (y/n)
4. Type and enter: y.
Response: PRM vBda 7400 xxyy zzzz hh hh hh printed on ROP.
Where: v = EorF.
xx = craft initialization level (0103o 03)
yy = craft initialization phase (0104o 04)
zzzz = 0000=current phase proceeds normally
0001=phase timed out
0002=craft initialization aborted
0003=craft initalization failed
0004=craft initialization completed successfully
Note: PRM EBda 7500 0000 0000 hh hh hh indicates that craft initialization
was denied because another craft initialization is already in progress.
5. Is craft terminal initialization successful?
If YES, STOP. YOU HAVE COMPLETED THIS PROCEDURE.
If NO, continue with next step.
235-200-150
January 2003
CORRECTIVE MAINTENANCE
Procedure 6.2
Issue 3.00 Page 6.2-1
To Next Page
Loading...
Need help?
General