7.1.2 Propagate Primary Disk to Secondary Disk
PROCEDURE
1. If the UNIX
1
console page is displayed, switch to the MCC of the AW, by holding
down the Ctrl key and pressing Enter (not Return).
2. If the emulator is running, halt the emulator. See “Halt the Administrative
Module (AM) Emulator,” Procedure 4.1.
3. Switch to the UNIX Console of the AW by holding down the Ctrl key and
pressing Enter (not Return).
4. If a login prompt does not appear, press Return repeatedly until one appears.
5. At the login prompt, login as awadmin, for example:
attaws console login: awadmin
6. From the Administrative Workstation Main Menu, select "Initialize a New
Workstation Disk”.
7. From the Disk Initialization menu, select "Execute initialization of a new
workstation disk." Answer yes to the following confirmation. If you select a task
by mistake, answer no to the confirmation.
Response:
You have chosen to initialize a new workstation disk. If the Emulator is
running, it must be halted before continuing. Refer to the Main Menu item
of Halt the Emulator.
Do you want to continue? (yes/no) yes
This operation will take approximately 30 minutes.
8. Has the Initialize a New Workstation Disk operation completed with the
following response?
Newdisk completed …
Press return to continue
If YES, press return and proceed with Step 9.
If NO, seek technical assistance.
9. From the “Disk Initialization Menu”, select “Return to the main menu”.
10. Is the AW a Netra
2
20 or Netra 240?
If YES, proceed with Step 11.
If NO, proceed with Step 15.
11. From the Administrative Workstation Main Menu, select “Backup the
workstation Operating System/Emulator to disk”. If you select a task by mistake,
answer no to the confirmation, and the main menu will return.
1. Registered trademark of The Open Group in the United States and other countries.
2. Registered trademark of Sun Microsystems, Inc.
235-200-150
October 2005
SYSTEM RECOVERY
Procedure 7.1.2
Issue 3.01 Page 7.1.2-1
To Next Page
Loading...