If NO, enter EAI poke 43 (clear application parameters), then repeat from Step 3.
If tape read problems continue, seek technical assistance.
14. Enter the parameters for the AM text session/volume you want to load (perform
the following substeps, then observe Notes 1, 2, and 3).
(a) Type and enter: 42
(b) Type and enter: s (session)
(c) Type and enter: 42
(d) Enter the session number for the AM text you want to load: 1
Observe the session PRM_0 E151 3331 FF01 EEEE displayed on the EAI
page. (See Note 1.)
(e) Type and enter: 42
(f) Type and enter: v (volume)
Observe the volume PRM_0 E151 3376 FF01 FFEE displayed on the EAI
page.
(g) Type and enter: 42
(h) Type and enter: 1 (AM text=1)
Observe the volume PRM_0 E151 3331 FF01 displayed on the EAI page.
(i) Observe PRM_0 E151 3600 FF01 FF01.
Sample Volume Search Results: PRM_0 E151 36xx FFss FFvv
Where: xx = 00 for volume was found.
xx = ff for volume was not found.
ss = Session number entered.
vv = Volume number entered.
Note 1: Step 14.d assumes that this is a single session multi-volume DAT.
If other session is to be used, enter the correct session number.
Note 2: If the session/volume request PRM is never printed, type and
enter: 43 to clear all application parameters, then repeat this step.
Note 3: If the volume was found, it takes approximately 20 minutes to
load AM text. A progression PRM prints while the tape is being loaded. If
the volume is not found, check the values entered or select another
session/volume, or seek technical assistance.
Tape Version PRM_0 E151 54xx xxxx xxxx xx xx xx
Program Version PRM_0 E151 7400 xxxx 0000 hh hh
Tape Load Progression PRM_0 E151 57xx xxxx xxxx
Tape Load Completion PRM_0 E151 59xx xxxx xxxx
Ready for Next Request PRM_0 E151 33xx EEEE EEEE hh hh hh
Tape Load Problem PRM_0 E151 xxxx xxxx xxxx
Disk Initialization PRM_0 E151 88xx xxxx xxxx
15. Did the tape load completion PRM print after the progression PRMs?
If YES, AM text has been loaded, continue with the next step.
235-200-150
January 2003
SYSTEM RECOVERY
Procedure 7.1.3
Issue 3.00 Page 7.1.3-3
To Next Page