18. Did the EAI Page respond with one of the following:
Boot? (y/n) or
BkRt Set! Boot (y/n)?
If YES, type and enter: y and continue with the next step.
If NO, continue with the next step.
19. Did the AM initialization complete successfully?
If YES, proceed to Step 47.
If NO, seek technical assistance and analyze the initialization failure.
20. Since switching module ODD must be loaded from tape because of a duplex
outboard disk failure, AM ODD must be loaded from tape.
Inhibit Recent Change. At the MCC Page 110, type and enter either: 605 or
INH:CORCS!
21. At the MCC Page 110, type and enter either: 606 or
INH:RC!
22. Type and enter:
INH:REORG!
23. Access the MCC Page 120.
Note: If the AM boots before the tapes are read in, the AM ODD that will
become active is the ODD BEFORE the last AM Backup.
24. Unmount the active partition (/dev/no5aodd1). Type and enter:
INH:FILESYS:UMOUNT,FN= "/dev/no5aodd1";
Response: INH FILESYS UMOUNT COMPLETED
25. To determine if the no5aodd1 partition is mounted, type and enter:
OP:STATUS:FILESYS;
26. Is the inactive partition /dev/no5aodd1 shown as mounted on /no5odd/data0?
If YES, seek technical assistance
If NO, continue with the next step.
27. Make the active partitions inactive and the inactive partitions active. Type and
enter:
COPY:FILESYS:FILE,SRC= "/no5text/rcv/aimrc", DEST="/no5text/rcv/aimrc.tmp";
Response: COPY FILESYS FILE COMPLETED
28. Type and enter:
COPY:FILESYS:FILE,SRC="/no5text/rcv/aimrc2", DEST= "/no5text/rcv/aimrc";
Response: COPY FILESYS FILE COMPLETED
29. Type and enter:
235-200-150
January 2003
SYSTEM RECOVERY
Procedure 7.1.4
Issue 3.00 Page 7.1.4-3
To Next Page