(a) Type and enter: toggle
Response: Will take you to the high-level forms.
3. Insert virtual TTY controller data.
Note: An ! may be entered any time prompted to abort the form and return to
the state when the form was started.
(a) Type and enter: vttycadd
Response: vttycadd form displayed. Cursor at 1. ttyc_name:
(b) Type and enter the following data:
1.vttyc_name: enter VTTYC name (VTTYC0 - VTTYC10,
VTTYC30 - VTTYC34)
2.slot
a
: enter0-15toselect a slot on VIOP 0
3.VIOP_number enter 0 as specified
Note(s):
a. To determine the slot availability on VIOP 0, at a selected terminal, type and
enter the command: OP:CFGSTAT:VIOP;.
(c) Type and enter: i
(d) First prompt: Remove VTTYC x from service. Enter CARRIAGE RETURN
to continue. At DRM MCC terminal, type and enter command:
RMV:VTTYC=x
Where: x = VTTYC number of the previous logical unit.
Response: RMV VTTYC x COMPLETED
(e) Second prompt: Restore VTTYC x to service. Enter CARRIAGE RETURN to
continue. At DRM MCC terminal, type and enter command: RST:VTTYC=x
Where: x = VTTYC number of the previous logical unit.
Response: RST VTTYC x COMPLETED
Note: During the growth of the first VTTYC, the VIOP 0 low-level forms
will automatically be added and there will be no prompts to remove/restore
previous logical units. There will be a prompt to restore the VIOP:
Prompt: Restore VIOP 0 to service. Enter CARRIAGE RETURN to continue.
At DRM MCC terminal, type and enter command: RST:VIOP=0
Response: RST VIOP 0 COMPLETED
(f) The low-level forms will now be added automatically.
Response: FORM INSERTED
4. Exit high-level forms.
(a) Type and enter: <
Response: Exit the vttycadd form UNIX RTR RCV (ODIN) - Data Entry
page displayed. Cursor at Enter Form Name:
(b) Type and enter: toggle
Response: Will take you to the low-level forms.
GROWTH AND DEGROWTH
Procedure 8.2
235-200-150
January 2003
Page 8.2-2 Issue 3.00
To Next Page
Loading...
Need help?
General