5. Restore TTY x to service.
(a) At MCC, type and enter the appropriate message:
RST:TTY=x
Where: x = appropriate TTY number.
If the Test Access Unit (TAU) is not being added to the STLWS,
continue with Step 11.
(b) Enter CARRIAGE RETURN
Response: FORM INSERTED
(c) Type and enter: <
Response: Exit the ttyadd form.
(d) Type and enter: <
Response: Exit this recent change session.
If the TAU is not being added to the STLWS, continue with Step 11.
6. Define the STLWS trunk group.
(a) Select and prepare terminal for Recent Change and Verify activities.
1. Is MCC or STLWS terminal to be used?
If MCC, proceed to substep a2.
Figure 8.3-3 — STLWS Installation (
Netra
240)
GROWTH AND DEGROWTH
Procedure 8.3
235-200-150
October 2005
Page 8.3-6 Issue 3.01
To Next Page
Loading...