5. Restore SDL0 to service.
(a) At MCC, type and enter the appropriate message:
RST:SDL=0
Response: RST SDL0 COMPLETED
(b) Enter CARRIAGE RETURN
Response: FORM INSERTED
(c) Type and enter: <
Response: Exit the sdladd form.
(d) Type and enter: <
Response: Exit this recent change session.
6. Backup Incore ECD to disk.
(a) At MCC, do Steps b through i.
Figure 8.7-3 — SCANS Data Link Hardware Installation (
Netra
240)
GROWTH AND DEGROWTH
Procedure 8.7
235-200-150
October 2005
Page 8.7-4 Issue 3.00B
To Next Page
Loading...