(a) Type and enter: toggle
Response: Will take you to the high-level forms.
3. Delete virtual TTY controller data.
Note: An ! may be entered any time prompted to abort the form and return to
the state when the form was started.
(a) Type and enter: vttycdel
Response: vttycdel form displayed. Cursor at 1. ttyc_name:
(b) Type and enter: VTTYCx
Where: x = VTTYC0 - VTTYC10, VTTYC30 - VTTYC34
Note: To see a list of equipped VTTYCs, at a selected terminal, type and
enter the command: OP:CFGSTAT:VIOP;.
(c) Type and enter: d
(d) First prompt: Remove VTTYC x from service. Enter CARRIAGE RETURN
to continue. At DRM MCC terminal, type and enter command:
RMV:VTTYC=x
Where: x = VTTYC number.
Response: RMV VTTYC x COMPLETED
(e) Second prompt: Remove VIOP/VTTYC x from service. Enter CARRIAGE
RETURN to continue. At DRM MCC terminal, type and enter command:
RMV:[VIOP,VTTYC]=x
Where: x = VIOP/VTTYC number of the previous logical unit.
Response: RMV [VIOP,VTTYC] x COMPLETED
(f) Third prompt: Restore VTTYC x to service. Enter CARRIAGE RETURN to
continue. At DRM MCC terminal, type and enter command: RST:VTTYC=x
Where: x = VTTYC number of the previous logical unit.
Response: RST VTTYC x COMPLETED
Note: During the degrowth of the last VTTYC, the VIOP 0 low-level forms
will automatically be deleted and there will be no prompt to restore
previous logical unit.
(g) The low-level forms will now be deleted automatically.
4. Exit high-level forms.
(a) Type and enter: <
Response: Exit the vttycdel form UNIX RTR RCV (ODIN) - Data Entry
page displayed. Cursor at Enter Form Name:
(b) Type and enter: toggle
Response: Will take you to the low-level forms.
5. Backup Incore ECD to disk.
GROWTH AND DEGROWTH
Procedure 8.15
235-200-150
January 2003
Page 8.15-2 Issue 3.00
To Next Page
Loading...