8.18 Perform RC/V Terminal Degrowth
PROCEDURE
1. Change Security
(a) At MCC, type and enter:
SET:RCACCESS,TTY=a,ACCESS=b
Where: a = ttys, ttyt, or ttyv
Where: ttys = TTY18
ttyt = TTY19
ttyv = TTY21
Where b is obtained from INPUT/OUTPUT manual.
(b) To check on the access code, type and enter message:
OP:RCACCESS,TTY=a
Where: a = ttys, ttyt, or ttyv
Where: ttys = TTY18
ttyt = TTY19
ttyv = TTY21
Response: Access code returned in hexadecimal
2. Remove TTY x from service.
(a) At MCC, type and enter the appropriate message:
Where: x = appropriate TTY number.
Response: RMV TTY x COMPLETED
3. Enter UNIX
1
RTR Recent Change and Verify.
(a) Is MCC or STLWS terminal to be used?
For MCC, proceed to Step b.
For STLWS proceed to Step i.
(b) At MCC, ensure terminal is in command mode.
(c) At MCC, do Steps d through h.
(d) Type and enter: 199
Response: RCV PARAMETER INFO page displayed with cursor at 1.
database_name
(e) Type and enter: incore
Response: 2. review only
(f) Type and enter: n
Response: 3. journaling
1. Registered trademark in the United States and other countries, licensed exclusively through X/Open
Company, Limited.
235-200-150
January 2003
GROWTH AND DEGROWTH
Procedure 8.18
Issue 3.00 Page 8.18-1
To Next Page
Loading...
Need help?
General