p = Active control unit (CU):
0––CU0
1––CU1
E = Informational PRM.
E = Application software generated this PRM.
d = Level of most recent UNIX RTR operating system initialization:
0 –– No initialization or D0 initialization.
1 –– D1 initialization.
2 –– D2 initialization.
3 –– D3 initialization.
4 –– D4 initialization.
These initializations are explained in 235-105-250, 5ESS Switch
System Recovery Manual.
a = Application initialization level within the UNIX RTR operating
system initialization specified in field ’d’.
5F06 = Application function = initialization timeout and completion.
xxxx = UNIX RTR operating system application process utility ID:
017 –– First in-first out (FIFO) driver (FDA).
0C0 –– Input/output driver (IODRV).
0C2 –– Scan and signal distributor administration (SCSD).
0CC –– RTR Data Link Driver for DRM
117 –– Plant measurement database monitor (PLDMON).
186 –– Kernel level overload monitor (KLMON)
188 –– UNIX RTR operating system supervisor overload monitor
process (SUOVPRC).
406 –– Process to load ODD onto Disk (PLOD).
407 –– Application data link (APDL).
410 –– Switch maintenance kernel process (switching module KP).
411 –– Switch maintenance power switch monitor (SMPSM).
420 –– Communications kernel process (CMKP).
430 –– Message switch kernel process (MSKP).
450 –– Pump control (PUCR).
451 –– Automatic message accounting disk writer (AMDW).
460 –– Operational kernel process (OKP).
590 –– Process for loading ODD into PAS (PLOP).
710 –– Switch Maintenance Diagnostic Input Message Processor
(SMDIMP). SMDIMP is also referred to as deferred maintenance
administrator and monitor (DMAM).
7ED –– Communications Module Processor Kernel Process
(CMPKP)
7DD –– Automatic message accounting disk writer 1 (AMDW1).
7CE –– Automatic message accounting disk writer 2 (AMDW2).
yy = Failed process sequence state.
235-200-150
January 2003
APPENDIX 2
PROCESSOR RECOVERY MESSAGES
Issue 3.00 Page A2-3
To Next Page
Loading...
Need help?
General