MAINTENANCE/SERVICE
Electrical System
LAMPS AND
BULBS
SERVIONG LAMP BULBS
1.
If all lights fail at the same time, check if re-set
button is popped out
on
the lights circuit
breaker
at
the engine. If so, push it in. See
"Circuit Breakers• in this section.
2. If a single lamp fails, bulb may be burned out,
or
it may have a faulty ground.
3.
If
problem
is
other than circuit breaker, bulb,
or
ground, see your Windrower dealer.
REPLAONG HEAD OR
FJELD
LAMPS
1. Turn lights and key
to
OFF.
2. Remove four screws from lamp bezel
(A)
.
3. Unplug connector
(B)
and connect
to
new
sealed beam.
NOTE: Replacement sealed beam trade # :
Head Lamp - (two
at
front center of cab):
#H
-
9411
Wide-Flood Field Lamp - (three each side of
cab):
#H
-9406
Medium-Flood Field Lamp - (one
at
rear of
tractor): #H-9414
4. Replace lamp and bezel, securing with four
screws.
REPLAONG A.ASHING AMBER
OR
RED TAIL
LIGHT BULBS
1. Remove
two
screws
(A)
. Remove plastic lens.
2. Replace bulb and reinstall plastic lens.
NOTE: Bulb trade #1156.
REPLACING
SEALED
BEAMS
AMBER
AND
RED
LIGHTS
82
To Next Page
Loading...
