1. To use Socket Communication Service make sure all parameters has been setup properly first:
(a) APN (+IPGPRS)
(b) host server (+SCHOST)
(c) pre-saved message (+SCMESS) (if needed)
(d) It is strongly suggested you have tested the socket communication function by using AT+SCSEND com-
mand to send test emails first before using SC Command Sting.r
2. When using SC service maximum 10 messages can be put on sending queue, further message sending re-
quests will be aborted. Buffered message queue is volatile and will be lost If modem Is powered off or reset.
Also when there is SC service in queue AT+SCSEND command will not be allowed.
104 Confidential, the whole document is the sole property of Maestro Wireless Solutions ltd.
support@maestro-wireless.com
To Next Page
Loading...
