Maestro M1002G - Email Sending (SMTP) Service; Description of the Operation; SMTP Server Configuration

Chapter 8
E-mail sending (SMTP) service
Be sure to have access to a SMTP server before using this feature. Network providers may have a dedicated SMTP
server, please verify connection details and availability with them first.
Modem is able to send an email via a SMTP server. Parameters like server name, address of sender and recipient,
email subject and email content need to be specified before sending an email, either by AT commands, or while using
Command String email service (See Chapter 21 for more details about Command String services).
8.1 Description of the Operation
1. Enter the following information by AT commands
1
:
(a) SMTP server information (address, port, login)
(b) Email addresses of sender and recipient(s)
(c) Email subject
(d) Email content
2. Make IP connection (see Chapter 2).
3. Use AT+EMSEND command to send out email (see Section 8.6).
4. An email can contain:
(a) Maximum up to 1024 (pre-saved) + 128 (command line additional) characters,
(b) Three group of recipient: "TO", "CC" and "BCC". Each group can have up to 64 characters of email
address(es),
(c) Subject up to 128 characters, from a choice 10 pre-saved subject record.
8.2 SMTP server
AT+IPSMTP
Command to setup SMTP server parameters.
Syntax: AT+IPSMTP=<port>,<auth>,<server>,<id>,<pwd>
Response: +IPSMTP: <port>,<auth>,<server>,<id>,<pwd>
Defined Values:
<port> port number of the SMTP server. Default value is 25.
<auth> authentication type used for authentication:
0 no authentication required (default),
1
Required information for a minimal email are: SMTP server, sender address and one recipient address
Confidential, the whole document is the sole property of Maestro Wireless Solutions ltd.
support@maestro-wireless.com
45