Chapter 15
Modem status check and monitoring
The modem status check and monitoring feature can check the status of the modem in either "one shot" or periodic
mode. Modem will also report checked result by SMS, if the result is beyond preset limit, and reset automatically if
losing network connection.
Following items will be checked:
– network registration (periodic mode only, triggering reset),
– ROM test,
– signal strength (can trigger reporting),
– IP address of modem (only when cellular connection activated).
15.1 Modem status check and monitoring
AT+TMODE
This command is to perform and setup modem status check and monitoring feature.
Syntax: AT+TMODE (=<mode>(,<para>))
Response: +TMODE: <test1>,<test2>. . . .
Defined Values:
<mode> 0 disable periodic mode check
1 enable periodic mode check
2
to
set
the
number
in
<para>
field
as
telephone
n
umber
for
periodic
mode
check
repor
ting.
3
to
set
the
number
in
<para>
field
as
network
signal
tr
igger
lev
el
for
per
iodic
mode
check
reporting. Range from 1-31.
4
to
set
the
<para>
field
as
input
v
oltage
tr
igger
le
vel
f
or
remote
repor
ting.
Range
0-5000.
Example:
Command Response
AT+TMODE +TMODE: 1,15,"10.111.222.33",3814
OK
Note : execute status check ("one shot" mode)
AT+TMODE=? +TMODE: (0-4),(20)
OK
AT+TMODE? +TMODE: 1,"1234567",10,3500
OK
Note: display current setting
Confidential, the whole document is the sole property of Maestro Wireless Solutions ltd.
support@maestro-wireless.com
75
To Next Page
Loading...
