Example:
Command Response
AT+EMADDR=0,0,"a@abc.com" OK
Note: store email address id #0 (sender address).
AT+EMADDR=0,1,"b@abc.com" OK
Note: store email address id #1.
AT+EMADDR=1,1 +EMADDR: 1,"b@abc.com"
Note: read stored address id #1.
AT+EMADDR=2,1 OK
Note: erase email address id #1.
AT+EMADDR=? +EMADDR: (0-2),(0-50),(64)
OK
Note:
– The program will NOT check if the address is in valid format or not.
– Email address stored with <id>=0 can only be used as of the sender address, not recipient.
– For each <id> you can save more than one email address, separated by comma, e.g. AT+EMADDR=0,1,"me@a.com,
you@a.com, him@a.com". But each address list limited to 64 characters.
8.4 Email subject
AT+EMSUBJ
To save, read and delete email subject (title).
Syntax: AT+EMSUBJ=<oper>,<id>,<subj>
Response: +EMSUBJ: <id>,<subj>
Defined Values:
<oper> type of operation:
0 store email subject to flash.
1 read email subject from flash.
2 erase email subject from flash.
<id> identification number (id) of the email subject. Valid value is 1 to 10.
<subj> email subject to be stored. Maximum 128 characters for each subject.
Example:
Command Response
AT+ EMSUBJ=0,1,"This is subj #1" OK
Note: store email subject #1.
AT+EMSUBJ=1,1 +EMSUBJ: 1,"This is subj #1"
Note: read stored email subject with id #1.
AT+EMSUBJ=2,1 OK
Note: erase email subject with id #1.
AT+EMSUBJ=? +EMSUBJ: (0-2),(1-10),(128)
OK
Note: It is recommend to use only alpha-numeric characters (ASCII value 32 to 127) for email subject content.
Confidential, the whole document is the sole property of Maestro Wireless Solutions ltd.
support@maestro-wireless.com
47
To Next Page
Loading...
