Maestro M1002G - SmartPack Version Command; Erasing the SmartPack Application

1.1 SmartPack version command
AT+VAFV
Display the revision details of the SmartPack installed on Maestro modem
Syntax: AT+VAFV
Response: <model>_SMARTPACK_<revision>_<module>_<firmware>_<date>
Defined Values:
<model> is the modem type, either:
M1002G for the cellular/EDGE version.
M1003G for the WCDMA version with gpsOne engine and USB connection. Applies also to the RS-
485 variant.
M100CDMAPLUS for the Verizon CDMA version with gpsOne engine and USB connection. Applies
also to the RS-485 variant.
<revision> is the version number of the SmartPack installed.
<module> is the Sierra Wireless module name.
<firmware> is the Sierra Wireless firmware required for this version of the SmartPack.
<date> is the build date of this version of the SmartPack.
Example:
Command
Response
AT+VAFV
M1002G_SMARTPACK_097e_SL6087_R746_250413
OK
AT+VAFV
ERROR
Note: SmartPack has not been properly loaded or installed.
Note:
– To verify the Sierra Wireless firmware version loaded in the modem please enter the command ATI3, for more
details on all the common AT commands available, please look in the Chapter 29.
– Be sure when updating the SmartPack that the required Sierra Wireless firmware is the correct one, otherwise
the SmartPack application may crash or have wrong behavior.
1.2 Erasing the SmartPack application
If you need to erase the SmartPack application please follow the commands listed in table 1.1.
Command Response Function
AT+WOPEN=0 OK Stop the application, modem will reset
AT+WOPEN=3 OK Erase configuration memory
AT+WOPEN=4 OK Erase flash memory, modem will reset
AT&F OK Factory default
Table 1.1: Erase Application
12 Confidential, the whole document is the sole property of Maestro Wireless Solutions ltd.
support@maestro-wireless.com