Chapter 28
SmartPack change log
Version 097g, on firmware R7.50
– Added SPMODE command to switch from SmartPack to WipSoft
– Added SPRESET command to reset all SmartPack settings to default. Can’t be entered remotely.
– Added IPDEBUG command to display TCP/IP stack debug message.
– Fixed signal LED that sometimes won’t flash even when network registration is OK
– Fixed Command String Input pin 2 triggering issue
– Fixed remote AutoTCP/UDP data not forwarded to serial port if socket is closed by remote peer within a very
short period
Version 2.2, on firmware R7.52.2 and R7.53.1
The version numbering has been updated to follow more clear versioning.
– Added MODESELECT, MODBUSCFG command to enable different serial mode and modbus converter on the
M100.
– Added SERIAL command to modify the serial port settings from USB port.
– Added a flag in SMSAT to disable SMS response.
– Added IPOPT option 5 and 6.
– Fixed IPCONNECT ERROR response with common AT command ERROR codes.
– Fixed CT service in command string.
– Fixed IPPING response.
– Fixed GP service in command string.
– Fixed IP service in command string.
– Fixed AL service in command string.
– Fixed OTCP on M100CDMAplus, on both serial and USB.
– Fixed IPSMTP command parameters.
– Fixed SMS text format (can send non capitalized text) in command string.
– Fixed SPRESET to erase every configuration.
– Improved IPTCP as a server socket connection.
Confidential, the whole document is the sole property of Maestro Wireless Solutions ltd.
support@maestro-wireless.com
129
To Next Page
Loading...
