Maestro M1002G - Sending a TCP Socket Message

2 erase saved message.
<id> identification number (id) of the message. Valid value is 1 to 3.
Example:
Command Response
AT+SCMESS=0,1 >
This is message #1<Ctrl-Z> +SCMESS: 1,18
OK
Note: enter message body with <id>=1. Note: successful stored 18 characters as message
with <id>=1.
AT+SCMESS=1,1 +SCMESS: 1
This is message body #1
OK
Note: read stored message with <id>=1.
AT+SCMESS=2,1 OK
Note: erase message body with <id>=1.
AT+SCMESS=? +SCMESS: (0-2),(1-3)
Note:
– Each message can contain up to 128 characters. All characters entered after 128
ht
will be discarded.
– On entering message to a same <id> old message will be over written.
9.4 Sending a TCP socket message
AT+SCSEND
To send a message to a pre-saved TCP host with or without one pre-saved message content, plus additional message
entered on command line. A minimum of 1 byte message needs to be sent otherwise it will send an error.
cellular connection (+IPCONNECT=1,1) must to be made and host parameters have to be entered properly before
sending otherwise will return +CME ERROR: 3.
When finishing a result code will be returned. Result code "0" means message transferred success, otherwise there
is error.
Syntax: AT+SCSEND= <to_id>,<mess_id>,<add_mess>
Response: +SCSEND : <result>
Defined Values:
<to_id> identification number (id) host entered using AT+SCHOST command. Valid value is 1 to 10.
<mess_id> identification number (id) of the saved message. Valid value is 1 to 3.
<add_mess> additional message to be sent. Maximum 128 characters can be sent. <add_body> will be added just
after message indicated by <mess_id> (if available).
<result> result code of the email sending process:
0 message sending successful.
-1 reserved (contact Maestro Wireless support).
-2 reserved (contact Maestro Wireless support).
Confidential, the whole document is the sole property of Maestro Wireless Solutions ltd.
support@maestro-wireless.com
53