Maestro M1002G - Forcing Device LED Off

Command
Response
AT+SERIAL?
+SERIAL: 115200,"8N1"
OK
Note: default settings.
AT+SERIAL=?
+SERIAL:
(300,600,1200,2400,4800,9600,19200,38400,57600,115200),
("8N1","8O1","8E1","8N2","7N1","7O1","7E1","7N2")
OK
AT+SERIAL=9600,"8E1"
OK
Note: set the new settings for the serial port
Note:
– This command won’t be set when the SmartPack is in SPMODE=0, customer will have to set his serial port
properly in this case.
1.7 Force device LED to be off
AT+LED
Enable user to force switch off the device led, for extra power saving.
Syntax: AT+LED=<state>
Response: OK
Defined Values:
<state> defines the state of the LED:
1 will switch off the LED.
0 will keep default behaviour.
Example:
Command
Response
AT+LED?
+LED: 0
OK
AT+LED=1
OK
Note: You will need to reboot to see the result
AT+LED=?
+LED: (0,1)
OK
Note:
– Reboot of the device is mandatory for it to apply properly.
Confidential, the whole document is the sole property of Maestro Wireless Solutions ltd.
support@maestro-wireless.com
15