Chapter 1
Introduction
Maestro SmartPack is a set of software solutions for Maestro 100 modem. Bundled functions added to increase the
utility range of various industrial and automated applications, such as:
– Automatic and self-recovery TCP/UDP socket connection
– AT command driven TCP/UDP socket connection
– Ping Service
– Dynamic DNS
– Input/Output and Analog
1
triggered AT command
– Email sending (SMTP)
– Remote AT command through SMS and TCP Terminal
– Call screening
– Modem status check and monitoring
– Remote program updating
– "Command String" programming scripts
– Socket data sending
– GPS control commands
2
User can configure and use the above features by following this document.
Target Users
This document is designed for system integrators or experienced hardware installers who are comfortable with all
aspects of IP based networking and have an understanding of serial based technologies such as dial-up modems,
AT commands and legacy data collection devices.
General behavior
Otherwise noted, each following command (AT+COMMAND) detailed in the user manual will reply as below:
OK Valid parameter string. Command is acknowledge.
ERROR Otherwise.
AT+COMMAND? Display the status of the current configuration.
AT+COMMAND=? Display the format and possible values of the command.
1
Analog input only available on M1002G
2
GPS only available on M1003GXT
Confidential, the whole document is the sole property of Maestro Wireless Solutions ltd.
support@maestro-wireless.com
11
To Next Page
Loading...
