Maestro M1002G - Automatic PIN Entry; Automatic PIN Entry Configuration

Chapter 16
Automatic PIN entry
The automatic PIN entry feature lets user to save a PIN code into the modem. When the modem detects a PIN
(PIN1) enabled SIM on starting, it will use the saved PIN code to unlock it. To prevent further PIN blocking user can
set minimum PIN remaining attempt number as a prerequisite for the automatic PIN entry operation.
16.1 Automatic PIN entry
AT+AUTOPIN
This command is to configure and enable/disable automatic PIN Entry feature
Syntax: AT+AUTOPIN=<mode> [,<pin>,<remain>,<unso>]
Response: +AUTOPIN: <mode>,<pin>,<remain>,<unso>
Defined Values:
<mode> default value is 0.
0 disable automatic PIN entry.
1 enable automatic PIN entry.
2 configure parameters.
<pin> four digit PIN code for automatic PIN entry. Default value is "0000".
<remain> minimum value of PIN remaining attempt number. If PIN remaining attempt number is less than the
value of <remain>, automatic PIN entry will not operate. Valid value is 1 to 3. Default value is 3.
<unso> default value is 0.
0 no unsolicited message.
1 unsolicited message +AUTOPIN: <pin_remain> will be displayed if <remain> is larger than
PIN remaining attempt number.
Confidential, the whole document is the sole property of Maestro Wireless Solutions ltd.
support@maestro-wireless.com
79