Maestro M1002G - Authorized Phone Number List Management; Reading Authorized Phone Number List

14.2 Authorized phone number list
AT+CSNW
This command is to enter authorized phone number.
Syntax: AT+CSNW=<id>,<num>
Response: OK
Defined Values:
<id> location of the authorized phone number to be stored. Valid range is from 1 to 10.
<num> authorized phone number. First digit can be "+", others must be numeric digits. Maximum length is 20.
Example:
Command Response
AT+CSNW=1,"12345678" OK
Note: enter authorized number to location 1.
AT+CSNW=11,"12345678" +CME ERROR: 3
Note: location out of range.
AT+CSNW=3,"1qaaa" +CME ERROR: 3
Note: non-numeric characters not allowed.
AT+CSNW=? +CSRN: (1-10),(20)
OK
Note:
– Enter phone number exactly same as the incoming one, especially if entering International phone number. Use
AT+CLIP command to check incoming call number first.
– Enter empty phone number in the <num> field will erase the record of that location.
14.3 Reading authorized phone number list
AT+CSNR
This command is to read authorized phone number entered.
Syntax: AT+CSNR=<id1>(,<id2>)
Response: +CSNR: <id>,<num>
Defined Values:
<id1> beginning location of the authorized phone number to be read. Valid range is from 1 to 10.
<id2> ending location of the authorized phone number to be read. Valid range is from 1 to 10.
72 Confidential, the whole document is the sole property of Maestro Wireless Solutions ltd.
support@maestro-wireless.com