Note:
– The I/O port is limited to drain maximum 10mA of current. Do not over voltage the I/O port.
– Use only cable/metal contact designed for Molex MicroFit connector.
– The application will NOT check the command <cmd> entered. It will execute the command even if the command
is invalid.
– When triggered, the command will not output any response to the external serial port.
– Do not enter "interactive" command (i.e +CMGS, +WDWL,...), otherwise the application will be stuck waiting for
user input.
– If +IOAT is enable, no other AT command can control the I/O port.
– Switching below 100ms cannot be detected by the modem.
Confidential, the whole document is the sole property of Maestro Wireless Solutions ltd.
support@maestro-wireless.com
65
To Next Page
Loading...
