Magnetek Impulse G+ series 4 User Manual

IMPULSE®•G+ & VG+ Series 4 Instruction Manual – February 2017
6-29
ndAT
Model, Voltage Class, Capacity Mismatch.
• The drive from which the parameters were
copied and the drive to which the
parameters will be written have different
electrical specifications, capacities, are set
to different control methods, or are different
models.
• The device being used to write the
parameters is blank and does not have any
parameters saved on it.
• Make sure model numbers and
specifications are the same for both drives.
• Make sure all connections are correct, and
copy the parameter settings onto the USB
Copy Unit or the operator.
rdEr
Error Reading Data. Failed while attempting
to read parameter settings from the drive.
Press and hold the READ key on the USB
Copy Unit for at least one second to have the
unit read parameters from the drive.
vAEr
Voltage Class, Capacity Mismatch. The
drive from which the parameters were copied
and the drive on which the Verify mode is
being performed have different electrical
specifications or are a different capacity.
Make sure electrical specifications and
capacities are the same for both drives.
vFyE
Parameter settings in the drive and those
saved to the copy function are not the
same. Indicates that parameter settings that
have been Read and loaded onto the Copy
Unit or Digital Operator are different.
To synchronize parameters, either write the
parameters saved on the USB Copy Unit or
digital operator onto the drive, or Read the
parameter settings on the drive onto the USB
Copy Unit.
Fault Display Fault or Indicator Name/Description Corrective Action

Magnetek Impulse G+ series 4 Specifications

General

Brand	Magnetek
Model	Impulse G+ series 4
Category	Controller
Language	English