IMPULSE®•G+ & VG+ Series 4 Instruction Manual – February 2017
6-32
8. Loosen the two retaining screws (A) pictured in Figure 6-2.
9. Remove existing interface card by grasping each corner at TB6 and TB5 and slide down until
free.
10. Return I/O board to ESD bag
11. Complete all main circuit terminal connections as the installation of the S4IF interface card may
block wiring access.
NOTE: Wires to the S4IF interface card should be stripped 0.2" ±20% for maximum system safety.
Solder dipping or ferrules are also highly recommended.
12. Insert the S4IF interface card by sliding it onto the side guides until it mates tightly into the CN4-
1 connector.
13. Tighten the screws (A) pictured in Figure 6-2.
14. Connect the command signals to the desired inputs of the S4IF interface card.
15. Refer to Table 3-8 for additional information regarding the S1, S2, S3, and S4 settings.
16. Reinstall and secure the drive's front cover.
17. Reconnect power to the drive.
18. Set A01-05 = 8880 (this moves all modified and user parameters to new IF card).
19. Verify modified parameters with those recorded in Step 1.
To Next Page
Loading...
Need help?
General
