Big-End Bearings
Inspection / Reassembly
A5.05. 02.04.02.00
M20
en / 07.01.2000 IB001357 4/4
02
Ĺ
3.7 Tightening check
3.7.1 Upper bolts 1 and 2: The maximum pointer must have been pulled beyond the angle
marking. When checking without gage, the bolts must have turned through an angle of
13° - 16°.
3.7.2 Lower bolts 3 and 4: The maximum pointer must have passed the angle marking or the
bolts must have turned through 17° - 19.
Note:
If these angles are not reached, undo the bolts with the ratchet handle (02.04.01.nn) and
check the parts for damage. For this, grease the threads and the contact faces of the bolts
again with Molykote paste “G-Rapid Plus”.
To Next Page
Loading...