Governor Drive
Inspection / Disassembly and reassembly
A5.05. 04.08.03.00
15000
M20
en / 05.06.2000 IB022022 1/3
04
Ĺ
See also:
Spare parts list: B1.05.04.2.4111
Time requirement: 1 Pers./ 2,00 h
Personnel qualification: skilled engine hand
---------------------------------------------------------------------------------------------------------------------
Operating medium: Heavy fuel and distillate fuel
Inspection:
Contact reflection at helical gear wheels every 15,000 h
Tools:
Torque wrench 40 - 180 Nm 1/2" W1 * 1.9454-40
* not available as figure
Auxiliary material:
Molykote paste “G-Rapid Plus” **
Silicon sealing compound “Dirco Gray” **
** or a product of equal standard
Sequence of operations:
1. Disassembly
1.1 Loosen the governor linkage from
the governor.
1.2 Unscrew the hexagon screws (Fig. 1/1)
and lift the governor (2) from the guide
of the governor housing (3).
1.3 Loosen the fillister head screws (4) and
lift the housing from the top edge of
the cylinder block and crankcase (3).
The housing is fixed with two dowel
pins (5).
Fig. 1
2
1
4
3
5
To Next Page
Loading...
General