Preservation
Depreservation
A3.09.03.00
M20-M601C
en / 15.12.1997 BA000416 2/2
Ĺ
2.5 Governor (mechanical-hydraulic regulator)
• Re-establish the correct oil level in the governor.
• Dial governors: remove any excess preserving grease from the gear wheels behind
the governor dial.
2.6 Turbocharger (with independent lubrication)
• If necessary, clean the preserved parts according to instructions of the manufacturer.
• Drain protective oil.
• Assemble new bearings and fill up oil.
2.7 External depreservation
• Remove corrosion inhibiting coating completely from all coated, bright engine parts, if
necessary, wash.
Attention:
The engine finish may not be etched by the cleaning and/or washing agent!
Use only correspondingly suitable washing agents!
Keep to operation, safety and sanitation instructions of the manufacturer!
To Next Page
Loading...