Parametrization start/stop
124
Read this manual carefully before starting any work!
This is particularly applicable to the chapter “General Safety Instructions”
and the respective safety instructions in the chapters.
“Display configuration” - set the start/stop stand in the display
Press button:
The following view is displayed:
Free IDs that are not yet used in the system
configuration are displayed under “SELECT stand
ID”.
An ID can be selected via “SELECT”.
In principle, it is irrelevant which of the free IDs is
selected; when the system configuration is
completed no more free IDs should be present!
If the display already has a parametrized start/stop
stand, it can be removed by clicking on the button
“Unregister stand”.
Alternatively, cancel the procedure with
“CANCEL”.
To Next Page
Loading...
Need help?
General