General safety instructions
17
Read this manual carefully before starting any work!
This is particularly applicable to the chapter “General Safety Instructions”
and the respective safety instructions in the chapters.
2.7 Safety equipment
The operating company must retrofit the following safety equipment:
Install emergency-stop device before the engine is put into operation and link to the system’s safety chain.
Connect the emergency stop equipment in such a manner that in case of an interruption of the power
supply or restoration of power supply after an interruption, hazardous situations for human beings and
property are ruled out.
The emergency stop facility must always be easily accessible.
DANGER
Risk of life from non-functional safety equipment and devices
For this reason:
S Before beginning work, check whether all safety equipment is functional and correctly installed.
S Prior to starting the engine, check whether all safety equipment and devices are working and have
been installed correctly.
S Never disable safety equipment or devices during operation.
2.7.1 Functional test emergency stop on the E-box
In order to timely detect failures, the emergency stop must be operated daily before the engine starts or
after all work on the E-box, so that dangerous situations do not occur for humans and machines.
See page 68.
To Next Page
Loading...
Need help?
General