General safety instructions
19
Read this manual carefully before starting any work!
This is particularly applicable to the chapter “General Safety Instructions”
and the respective safety instructions in the chapters.
2.9 Signage
The following icons should be placed near the hazard zone.
WARNING
Risk of injury from inadequate labeling
For this reason:
S Make sure all safety, warning and operational notices or instructions are always clearly legible.
S Clean or replace illegible safety, warning and Operating Instructions.
Electrical voltage
Only electricians may carry out work in working areas marked in this manner.
Unauthorized persons should not enter areas marked in this manner.
Hot surfaces
Hot surfaces, such as engines and hot liquids are not always perceptible. Do not touch
them without safety gloves.
Risk of life from suspended loads
During hoisting operations, loads may sway outwards and fall down. This may cause
severe injuries and may even lead to death.
Follow the instructions
The instructions must be read and understood fully prior to any work being started.
The work may only be performed by personnel conforming to the specifications in the
section on personnel requirements.
To Next Page
Loading...
Need help?
General