Parametrization of emergency drive
127
Read this manual carefully before starting any work!
This is particularly applicable to the chapter “General Safety Instructions”
and the respective safety instructions in the chapters.
15 Parametrization of emergency drive on 7" touch display
General information:
This function is available for the non-classified application with 7 inch touch display. (The dual display, two
engines on one display, is also excepted from this.)
As maximum equipment, up to six displays with emergency operation functionality can be parametrized for
each engine.
15.1 Parametrization
Entry via the main menu
Then switch to the sub-menu
The page Emergency Drive Settings opens:
Left “area”:
Serves for “System configuration” (functionality of
the displays from one engine in the network) – the
number of “emergency operator's stands
configured in the system” is displayed.
Right “area”
Serves for configuration of this display – shows the
ID with which the emergency operator's stand is
parametrized in the display.
To Next Page
Loading...
Need help?
General