Parametrization start/stop
126
Read this manual carefully before starting any work!
This is particularly applicable to the chapter “General Safety Instructions”
and the respective safety instructions in the chapters.
Error message: “Start Stop Error/Name claiming failed”
In the display on which the error message is
displayed, a start/stop stand is parametrized with
an ID that is already present in the system
network..
Possible causes/procedure:
S Re-parametrize start/stop stand in the display
→ “Unregister stand”, then configure again.
Example of an error message that always occurs
during parametrization:
During system parametrization one start/stop
stand was set but no other parametrization yet
undertaken. The following error message is output:
The start/stop stand with the ID 1, 2 is not found.
Then configure the start/stop stand in the display
provided for the start/stop functionality.
To Next Page
Loading...