Table of contents
3
Read this manual carefully before starting any work!
This is particularly applicable to the chapter “General Safety Instructions”
and the respective safety instructions in the chapters.
1 Preface 7...........................................................................
1.1 General 7......................................................................
1.2 Copyright protection 8...........................................................
1.3 Safety instructions 8............................................................
1.4 Liability for material defects 8.....................................................
1.5 Explanation of icons 9...........................................................
2 General safety instructions 10.........................................................
2.1 Introduction 10..................................................................
2.2 Proper use 10...................................................................
2.3 Conversions and modifications to the engine and aftertreatment system 11..............
2.4 Requirements of personnel 12.....................................................
2.5 Personal protective equipment 13..................................................
2.6 Special hazards 14...............................................................
2.7 Safety equipment 17.............................................................
2.7.1 Functional test emergency stop on the E-box 17................................
2.8 Conduct in the even of hazards and accidents 18....................................
2.9 Signage 19......................................................................
2.10 Environmental protection 20.......................................................
3 Functional safety 21..................................................................
3.1 The following development guidelines and principles apply 22..........................
3.2 Definition of system scope 22......................................................
3.2.1 „Non class“ - Application 23..................................................
3.2.2 “Class” Application 24.......................................................
3.3 Boundary conditions and consequences of non-observance 25.........................
4 Electromagnetic compatibility (EMC) 26................................................
5 System overview 29..................................................................
6 Design and function of the electronics box (E-box) 31..................................
6.1 Versions of the electronics box 31..................................................
6.2 Components of the electronics box 34..............................................
6.2.1 Internal drive lever control unit MPC 34........................................
6.2.2 Motherboards 35...........................................................
6.2.3 Monitoring and Control System (MCS) - control unit 38..........................
6.2.4 Connector board 39.........................................................
To Next Page
Loading...
Need help?
General