Installation
58
Read this manual carefully before starting any work!
This is particularly applicable to the chapter “General Safety Instructions”
and the respective safety instructions in the chapters.
8.3 Overview of plugs on the electronics box with acceptance
Plug assignment
X1 Connection of engine - E-box alarm system
X4 Connection plug for shipyard-side wiring.
X6 CAN connection of the display instruments/displays
X7 Reserve
X8 Gearbox feedback signals
X9 Connection for external drive lever control
X10 Connection for diagnostics software (only for MAN Service).
X16 Connection of override button for alarm system
X17 Display on the bridge as to whether “Local” or “Remote” status is active
X23 Without function, only reserve
X24 Without function, only reserve
X28 Ethernet temporary
X28/2 Ethernet permanent M12 interface
Note: Do not use connections at the same time, either X28 or X28/2
X50 Connection of engine - E-box safety system
X21 Potential-free contacts alarm relay from alarm system for ship
X41 Potential-free contacts alarm relay from safety system for ship
X47 Connection of override button for safety system
X88 Reserve/partial access to internal drive lever control unit; not on connector board (optional)
(1) PG gland: Cable conduit for internal drive lever control unit
Connecting cables, see page 116.
To Next Page
Loading...
Need help?
General