Control and operation
77
Read this manual carefully before starting any work!
This is particularly applicable to the chapter “General Safety Instructions”
and the respective safety instructions in the chapters.
9.2.1 Display menu touch display
Depending on the equipment and the application of the engines, some display functions are restricted or
not available. The versions shown here show the maximum potential applications of the display functions.
Configuration/commissioning page
Non-classified application:
Switching the display between “Single engine
display” or “Dual engine display” and with/without
CAN converter (Prerequisite for twin engines
1 Prerequisite for twin engines:
- CAN connection to both engines and
- only engines without exhaust aftertreatment
system
Classified application:
Selection between “Bridge” and “Engine control
room” and with/without CAN converter
Note:
Here, the bridge display has no optical quit and
reset function
To Next Page
Loading...
Need help?
General