Manitowoc Grove RT9130E-2 - Page 155

4-27
RT9130E-2 OPERATOR MANUAL SET-UP AND INSTALLATION
4
Published 3-1-2018, Control # 559-03
GROVE
NOTE: For technical reasons a crane may only be set with
one jib.
If you wish to use the jib on several Grove cranes, the parts
of the jib must be adjusted for these cranes and labelled with
all of the respective serial numbers.
Serial Numbers On the 8 m (26 ft) Inserts
On the 8 m (26 ft) inserts the serial number (1) is at the front
(Figure 4-17).
Slinging Points
The 8 m (26 ft) inserts have two slinging points (1) (each
slightly offset on each side) (Figure 4-18).
CAUTION
Have the adjustment of the jib carried out only by your
local Grove Distributor or Manitowoc Crane Care.
1
FIGURE 4-17
w1520a
WARNING
This section shows the slinging points on the 8 m (26 ft)
inserts. Attach the sling or chains to these slinging points
only. They will then have the correct center of gravity. Use
only lifting gear with sufficient load bearing capacity.
1
FIGURE 4-18
w1519a