Grove Published 01-29-2015, Control # 512-01 2-17
TMS700E SERVICE MANUAL HYDRAULIC SYSTEM
4. Place the pump drive mounting plate and attached parts
on the transmission. Secure the pump drive mounting
plate to the transmission with bolts and hardened
washers.
5. Place the support straps on each side of the pump drive.
Secure them to the rear engine mounts and the pump
drive upper support with attaching hardware.
6. Connect the prop shaft to the pump drive with four 1/2-
20 bolts and washers. If the prop shaft was also
disconnected from the engine’s PTO shaft, reconnect
them using four 7/16-14 screws, nuts, and washers.
Torque the 7/16-14 screws according to Fasteners and
Torque Values, page 1-12.
7. Connect the electrical connectors to the air solenoids
and the indicator light switch as tagged during Removal.
8. Connect the air lines to the disconnect controls as
tagged during Removal.
9. Install the No. 1 Pump per installation instructions in this
section.
10. Service the pump drive. Refer to Lubrication, page 9-1.
11. Operate all components and check for leaks and proper
operation. Also verify the air-powered disconnect
function works. Make adjustments or repairs as needed.
Reference Only
To Next Page
Loading...
Need help?
General
