Manitowoc Published 05-26-17, Control # 238-02 7-13
MLC165-1 SERVICE/MAINTENANCE MANUAL POWER TRAIN
12. Once coolant is visible at the full cold mark on the decal
next to the sight glass (Figure 7-9, page 7-11
), wait 2-3
minutes, then add coolant again as needed.
13. Start the engine and run it until the thermostat opens at a
coolant temperature of 181-199°F (83-93°C).
14. Reduce engine speed to low idle for two minutes to cool
down the engine components, then turn off the engine.
15. Once the engine has cooled, add coolant until it is visible
at the full cold mark on the decal next to the sight glass.
16. Install the fill cap and install the access cover.
WARNING
Chemical and Burn Hazard
Coolant could spray from an open radiator cap while the
engine is running. Do not stand near the radiator while
operating the engine with the pressure cap removed.
Coolant is toxic. Do not ingest. If not reused, dispose of in
accordance with all local and other applicable
environmental regulations.
To Next Page
Loading...
