Mark-10 F Series - Pre-Test Setup Parameters

Series F Test Frames + IntelliMESUR
®
Software User’s Guide
30
TOC 
The Basic Test Wizard consists of four steps. Each stepped is grouped into panels containing settings.
The four steps are as follows:
1. Pre-Test Setup
2. Test Setup
3. Results Setup
4. Post-Test Setup
8.1.1 Pre-Test Setup
Basic Setup Panel
Load Unit
Select the desired unit of measurement. Note that not all units are supported by all force sensors
cells. Refer to the sensor’s specifications for a list of supported units.
Distance Unit
Select the desired unit of measurement.
Zero Load
Zero the load value at the start of the run.
Zero Distance
Zero the position value at the start of the run.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com