Mark-10 F Series - Page 41

Series F Test Frames + IntelliMESUR
®
Software User’s Guide
41
TOC 
Basic Settings
Cycle Type
Select number of cycles, or specify a period of time, in hours, minutes, and seconds.
Up Stroke / Down Stroke Settings
Up Stroke (crosshead moving up or right) and Down Stroke (crosshead moving down or left)
settings may be set independently of each other. The crosshead will stop at one of the following
three targets:
Load
Select tension or compression, then specify the load.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com