Mark-10 F Series - Page 46

Series F Test Frames + IntelliMESUR
®
Software User’s Guide
46
TOC 
9.2.3 Loop
The Loop function repeats a range of steps. Insert this step after the last step to be repeated.
Select either a number of loops or a time duration for constant looping. Then, enter the Starting Step
number. Enter Number of Loops or Duration.
9.2.4 Datum
A datum establishes a local offset of load and/or distance. When the datum step is reached, the displayed
load and/or distance will change by the values set in the Load and Distance fields. Enable one or both of
these fields.
Note that datums do not change the system offset established in the Height / Length Offset utility, but
rather, only offsets the data collected during the test.
To include the data points received during the Hold step in the Results calculations, enable Display
Results.
Up to two datums may be used per test.
9.2.5 Prompt
Setting up a prompt in a multistep test is the same as described in the Basic Test Setup section.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com