Mark-10 F Series - Page 54

Series F Test Frames + IntelliMESUR
®
Software User’s Guide
54
TOC 
Below is an example of a one-loop, two-cycle multi-step test:
The following additional information is displayed in a multi-step test versus a basic test:
Run No.
Run number.
Step No.
Indicates the step number within the multi-step sequence. Only steps configured to display results
are shown in this table.
If more than one loop is configured in the test, the table includes the Loop No. and Cycle Count
columns, as shown below:
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com