Series F Test Frames + IntelliMESUR
®
Software User’s Guide
Since any number of loops may be configured in a multi-step test, Loop No. identifies the loop
within the test. Cycle Count refers to the cycle number within a specific Loop step.
Overall Run Status
When there is more than one pass/fail status per run, an additional row is added to the Results
table, labeled Overall Run. This provides a comprehensive pass/fail determination for the entire
run. If all steps pass, the Overall Run status is Pass. If any step fails, the overall status is Fail.
Basic information and test start and stop functions are the same as in the Graph screen.
10.3.2 Results Presentation
If the run fails, the entire row will appear red, and the Status cell includes a description of the failure.
Example:
An exception is denoted in the same manner. Example:
When an exception occurs, the crosshead stops. It will not return to the Home position, even if Return
Home is enabled in the test setup. To manually return home, select Return Home.
10.3.3 Invalidating a Result
There may be an occasion where the result must be invalidated; for example, if the test was started
accidentally, or the sample slipped out of the grip. In such instances, a run may be invalidated.
Highlight anywhere within the row, then select Invalidate Run. A message box appears as follows:
Then select the reason from a pre-populated list, or select Other and enter a custom reason.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
Need help?
General
