106 Appendix F: The Matrox Iris GTR breakout board
- Optionally, connect up to three third-party devices that require input to the
Matrox Iris GTR breakout board output connector. For more information,
refer to Output connector subsection of the Open-wire connectors reference
section, later in this appendix.
❖
Note that, if an auxiliary output signal is in sinking mode, then all auxiliary
output signals must be in sinking mode. If one is in sourcing mode, then the
other auxiliary output signals are no longer available.
- If using a lighting controller (such as, an Advanced Illumination inline control
system (ICS3), a Smart Vision Lights Brick light, or a similar device), connect
it to the ICS3 connector. For more information, refer to ICS3 connector
subsection of the Open-wire connectors reference section, later in this appendix.
5. To power your Matrox Iris GTR breakout board, you can use one of two
connectors: the DC power socket (J3) or the power screw wire-terminals (J2).
To connect to the DC power socket (J3):
a. Connect the external power supply, included in your Matrox Iris GTR starter
kit, to the DC power socket (J3) of the power source connectors on your Matrox
Iris GTR breakout board.
b. Then, connect the external power supply to your AC power source.
Alternatively, if your cable does not have a DC power plug, connect the power
and return path wires from your power source to the screw wire-terminals (J2),
respectively. Then, connect the external power supply to your AC power source.
❖ Note that a screw wire-terminal differs slightly from a spring wire-terminal, in
that it uses screws to keep the wires tight. To open a screw wire-terminal to accept
a wire, loosen the screw at the front of the wire-terminal. Once the tinned wire is
in place, tighten the screw until the wire is firmly held. Repeat for the second wire.
To Next Page
Loading...
