30 Chapter 2: Powering and connecting to your Matrox Iris GTR
Adding Matrox Iris GTR to your network
Corporate-wide networks typically use DHCP servers to assign each connected
device an IP address. If your Matrox Iris GTR is still in its factory-configured state,
and your network uses a DHCP server, no configuration is required to use your
Matrox Iris GTR on your network.
Much of the information found in this section is directed to users with a Matrox
Iris GTR camera with Matrox Design Assistant, because in this case, the camera
uses the Matrox Imaging Operating System (MIOS). There are some differences
if you are using Matrox Iris GTR with MIL-only because it uses a Windows 10
IoT operating system. Some differences include:
• Access to the Matrox Design Assistant configuration portal is not available. Some
settings, such as TCP/IP, can be changed through the Settings menu in Windows
10 IoT, instead of the Matrox Iris GTR configuration portal.
• The Matrox Iris GTR Discovery utility is not available.
• Configuration settings must be changed the same way as any other Windows 10
IoT operating system; refer to the relevant Windows documentation for this
information.
To Next Page
Loading...
