Matrox Iris GTR5000 - Page 29

Reading the state of your Matrox Iris GTR 29
The Power and User LEDs typically display one of the following sets of colors:
The Status LED typically displays one of the following sets of colors:
100/1G LED typically shows the connection status of your Matrox Iris GTR:
LED Color Description
Power User
Off Off Matrox Iris GTR has no power.
Red
Red
a
a. This LED is not pre-configured on the Matrox Iris GTR with MIL-only smart cameras, but can be configured using Msy-
sControl with M_LED_USER.
Power is available, but your Matrox Iris GTR is not responding.
Red
Orange
a
Memory initialization error detected.
Orange
Orange/Red blink
a
Thermal trip detected.
Orange Orange BIOS execution in progress.
Orange
Green
a
BIOS execution completing.
Green
Off
a
Matrox Design Assistant is now in control.
Green
Orange
a
Operating system startup in progress.
Green
Green
a
Camera ready.
Green
Orange/Off blink
a
Overheat detected. Temperature is above the throttle temperature limit.
LED Color Description
Off There is no power.
Red Matrox Iris GTR is booting.
Red/Orange Sensor has not been attached or initialized yet.
Orange The Matrox Iris GTR acquisition section is initializing. A MIL or Matrox Design Assistant
application could also be waiting for a trigger or using image files from disk.
Green The Matrox Iris GTR acquisition section is grabbing an image.
LED Color Description
Off There is either no activity or a low speed (10 Mbits) connection between your
Matrox Iris GTR and the network.
Solid yellow There is a link on the 100 Mbits/sec connection.
Blinking yellow The 100 Mbits/sec connection has activity.
Solid green There is a link on the 1 Gbit/sec connection.
Blinking green The 1 Gbit/sec connection has activity.