Adding Matrox Iris GTR to your network 31
Device name (AUTO NETNAME)
By default, Matrox Iris GTR comes factory configured with a device name (AUTO
NETNAME), which can be found on a sticker attached to your Matrox Iris GTR
smart camera and is unique for each camera. If you are connecting to a static
network, use the IP address of the camera; otherwise, if you are connected to a
DHCP network, this name is used:
The XXXX corresponds to the last four hexadecimal digits of your Matrox
Iris GTR’s MAC address. This can be changed to a more meaningful name
through the Matrox Design Assistant configuration portal.
The Matrox Design Assistant configuration portal on your Matrox Iris GTR is
located at http:\\GTR32XXXX, where GTR32XXXX is your smart camera’s device
name. This portal allows you to manage many aspects of your smart camera (for
example, configure settings, manage projects, and set up communication). You
can change network settings in the TCP/IP tab of the Administration page (gear
icon), where you can also change the device name (AUTO NETNAME) of your
camera.
Using a static IP address with networks that do not use DHCP
If your network does not use DHCP, you must access and configure your Matrox
Iris GTR to use a static IP address. To access Matrox Iris GTR when you don’t
know its current IP address, you can physically connect to it or use the Matrox
Iris GTR Discovery utility on your development computer.
Connecting directly to your Matrox Iris GTR
If you do not know your Matrox Iris GTR’s IP address, you can physically connect
to it and change its IP address; to do so for a Matrox Iris GTR, perform the
following:
1. Connect your Matrox Iris GTR to a monitor, mouse, and USB keyboard. Then,
turn on the connected monitor, mouse, and USB keyboard before plugging in
your Matrox Iris GTR to a power source.
2. On your Matrox Iris GTR, launch your web browser, and go to the following
address:
GTR32XXXX
http:\\localhost
To Next Page
Loading...
